Page 1 of 1
Crashing losing all information
Posted: Sat Oct 25, 2014 10:09 pm
by treimor
So i spent probably 2-3 hours last night writing functions/trigs and such. I got home from work today, and when i went to use mudlet (i never closed it), it crashed. I lost everything i did last night, and i don't know why.
Does mudlet not actually save your settings as you create them? do i need to explicitly save the file after every new thing i add? A little bit frustrated to lose 30+ functions and settings.
Re: Crashing losing all information
Posted: Sat Oct 25, 2014 10:16 pm
by treimor
Nevermind, i just read the tooltip that crashing will not save any changes. I guess i'll have to get into the habit of non-stop saving.
Re: Crashing losing all information
Posted: Sat Oct 25, 2014 10:30 pm
by Silvine
I treat everything to do with computers the same way, when I do something I want to keep I save it. This started about 30 years ago when the power went off when I was in the middle of PRINT "Hello Wor
Re: Crashing losing all information
Posted: Sun Oct 26, 2014 7:03 am
by Vadi
The 'save profile' button on top saves (and creates a snapshot you can revert to).
Re: Crashing losing all information
Posted: Sun Oct 26, 2014 3:08 pm
by Belgarath
Hehe. I actually made a complaint about this in an earlier forum post. Not much to do about it unless you load your scripts in from a separate file.
I just save my profiles religiously now as a habit. To deal with so many profiles being saved I just add deleteOldProfiles to an event when Mudlet closes.